Openwrt/target/linux
Jiawei Wang 9c500db896 ramips: fix used MAC addresses for Phicomm K2P
The factory partition of the Phicomm K2P contains two MAC addresses.
The lower MAC address is at offset 0xe006 and the higher one is at
offset 0xe000.

Use the lower MAC address as base mac-address which the switch driver
increments by one for the second (wan) vlan.

The MAC addresses are still inverted in contrast to the stock firmware
where the lower MAC address is used for wan. But at least the use of a
MAC address not intended/reserved for this particular board is fixed.

Signed-off-by: Jiawei Wang <me@jwang.link>
2017-09-15 07:14:29 +02:00
..
adm5120
adm8668
apm821xx
ar7
ar71xx ar71xx: fix MAC addresses on TP-Link TL-WR1043ND v4 2017-09-11 19:47:19 +02:00
arc770
archs38
armvirt
at91
ath25
au1000
bcm53xx kernel: update 4.4 to 4.4.86 2017-09-05 08:43:39 +02:00
brcm47xx
brcm63xx kernel: update 4.4 to 4.4.86 2017-09-05 08:43:39 +02:00
brcm2708
cns3xxx cns3xxx: fix GPIO controller interrupt enable 2017-09-11 17:03:21 +02:00
gemini
generic generic: drop support for get_port_stats() on ar8xxx 2017-09-13 08:07:54 +02:00
imx6
ipq806x
ixp4xx
kirkwood
lantiq kernel: update 4.9 to 4.9.49 2017-09-11 01:56:14 +02:00
layerscape
malta
mcs814x
mediatek kernel: update 4.9 to 4.9.49 2017-09-11 01:56:14 +02:00
mpc85xx
mvebu
mxs
octeon
omap
omap24xx
orion
oxnas
pistachio
ppc40x
ppc44x
ramips ramips: fix used MAC addresses for Phicomm K2P 2017-09-15 07:14:29 +02:00
rb532
sunxi
uml
x86
xburst
zynq
Makefile