b30f2281cc
The GL.iNet microuter-N300 (internally referred as MT300N-v4) is a
pocket-size travel router. It is essentially identical to the VIXMINI
(internally referred as MT300N-v3) but with double the RAM and
SPI-flash.
Additionally, set the label-mac for both the VIXMINI as well as the
microuter-N300.
Hardware
--------
SoC: MediaTek MT7628NN
RAM: 128M DDR2
FLASH: 16M
LED: Power - WLAN
BTN: Reset
UART: 115200 8N1
TX and RX are labled on the board as pads next to the SoC
Installation via web-interface
------------------------------
1. Visit the web-interface at 192.168.8.1
Note: The ethernet port is by default WAN. So you need to connect to
the router via WiFi
2. Navigate to the Update tab on the left side.
3. Select "Local Update"
4. Upload the OpenWrt sysupgrade image.
Note: Make sure you select not to preserve the configuration.
Installation via U-Boot
-----------------------
1. Hold down the reset button while powering on the device.
Wait for the LED to flash 5 times.
2. Assign yourself a static IPv4 in 192.168.1.0/24
3. Upload the OpenWrt sysupgrade image at 192.168.1.1.
Signed-off-by: David Bauer <mail@david-bauer.net>
22 lines
361 B
Plaintext
22 lines
361 B
Plaintext
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
|
|
/dts-v1/;
|
|
|
|
#include "mt7628an_glinet_vixmini_microuter.dtsi"
|
|
|
|
/ {
|
|
compatible = "glinet,vixmini", "mediatek,mt7628an-soc";
|
|
model = "GL.iNet VIXMINI";
|
|
};
|
|
|
|
&led_power_blue {
|
|
label = "vixmini:blue:power";
|
|
};
|
|
|
|
&led_wlan_white {
|
|
label = "vixmini:white:wlan";
|
|
};
|
|
|
|
&firmware_part {
|
|
reg = <0x50000 0x7b0000>;
|
|
};
|