Openwrt/target/linux
David Bauer 6476148034 ath79: add support for OCEDO Raccoon
This commit adds support for the OCEDO Raccoon

SOC:	Atheros AR9344
RAM:    128MB
FLASH:  16MiB
WLAN1:  AR9344 2.4 GHz 802.11bgn 2x2
WLAN2:  AR9382 5 GHz 802.11an 2x2
INPUT:  RESET button
LED:    Power, LAN, WiFi 2.4, WiFi 5
Serial: Header Next to Black metal shield
        Pinout is 3.3V - GND - TX - RX (Arrow Pad is 3.3V)
        The Serial setting is 115200-8-N-1.

	NOTE: The U-Boot won't boot with the serial attached.
	Boot the device without serial attached and attach it
	after 3 seconds.

Tested and working:
 - Ethernet
 - 2.4 GHz WiFi
 - 5 GHz WiFi
 - TFTP boot from ramdisk image
 - Installation via ramdisk image
 - OpenWRT sysupgrade
 - Buttons
 - LEDs

Installation seems to be possible only through booting an OpenWRT
ramdisk image.

Hold down the reset button while powering on the device. It will load a
ramdisk image named 'raccoon-uImage-initramfs-lzma.bin' from 192.168.100.8.

Note: depending on the present software, the device might also try to
pull a file called 'raccoon-uimage-factory'. Only the name differs, it
is still used as a ramdisk image.

Wait for the ramdisk image to boot. OpenWRT can be written to the flash
via sysupgrade or mtd.

Due to the flip-flop bootloader which we not (yet) support, you need to
set the partition the bootloader is selecting. It is possible from the
initramfs image with

 > fw_setenv bootcmd run bootcmd_1

Afterwards you can reboot the device.

Signed-off-by: David Bauer <mail@david-bauer.net>
2018-07-08 00:04:27 +02:00
..
adm5120
adm8668
apm821xx
ar7
ar71xx ar71xx: factor out safe loader image build code 2018-07-07 21:07:40 +02:00
arc770
archs38
armvirt
at91 kernel: remove DEVMEM and DEVKMEM from target's config 2018-07-07 18:19:39 +02:00
ath25
ath79 ath79: add support for OCEDO Raccoon 2018-07-08 00:04:27 +02:00
au1000
bcm53xx
brcm47xx
brcm63xx
brcm2708 brcm2708: platform.sh: fix tar directory directive 2018-07-07 18:19:39 +02:00
cns3xxx
gemini kernel: remove DEVMEM and DEVKMEM from target's config 2018-07-07 18:19:39 +02:00
generic kernel: move CONFIG_USB_MTU3 to generic config 2018-07-07 23:53:04 +02:00
imx6
ipq40xx
ipq806x
ixp4xx
kirkwood
lantiq
layerscape kernel: remove DEVMEM and DEVKMEM from target's config 2018-07-07 18:19:39 +02:00
malta
mcs814x
mediatek kernel: move CONFIG_USB_MTU3 to generic config 2018-07-07 23:53:04 +02:00
mpc85xx WDR4900v1 remove dt node for absent hw crypto. 2018-07-07 18:19:39 +02:00
mvebu
mxs
octeon
octeontx
omap
omap24xx
orion
oxnas kernel: remove DEVMEM and DEVKMEM from target's config 2018-07-07 18:19:39 +02:00
pistachio
ppc40x
ppc44x
ramips ramips: add support for Blueendless Kimax U35WF 2018-07-07 21:07:40 +02:00
rb532
sunxi sunxi: Enable SD block devices 2018-07-07 18:19:39 +02:00
uml
x86
xburst
zynq
Makefile