Openwrt/target/linux/ath79
Roger Pueyo Centelles a0ef42e77c ath79: add support for Ubiquiti PowerBeam 5AC 500
The Ubiquiti PowerBeam 5AC 500 (PBE-5AC-500) is an outdoor 802.11ac
5 GHz bridge with a radio feed and a dish antenna.

Specifications:
 - SoC: Qualcomm Atheros QCA9558
 - RAM: 128 MB DDR2
 - Flash: 16 MB SPI NOR (mx25l12805d)
 - Ethernet: 1x 10/100/1000 Mbps Atheros 8031, 24 Vdc PoE-in
 - WiFi 5 GHz: QCA988x HW2.0 Ubiquiti target 0x4100016c chip_id 0x043222ff
 - Buttons: 1x (reset)
 - LEDs: 1x power, 1x Ethernet, 4x RSSI, all blue
 - UART: not tested

Not supported:
 - RSSI LEDs (probably through 74HC595 chip)

Installation from stock airOS firmware:
 - Follow instructions for XC-type Ubiquiti devices on OpenWrt wiki at
   https://openwrt.org/toh/ubiquiti/common

Signed-off-by: Roger Pueyo Centelles <roger.pueyo@guifi.net>
2020-05-17 21:03:30 +02:00
..
base-files/etc/hotplug.d/ieee80211
dts ath79: add support for Ubiquiti PowerBeam 5AC 500 2020-05-17 21:03:30 +02:00
files ath79: ag71xx: unify version dependent code 2020-04-27 12:21:45 +02:00
generic ath79: add support for Ubiquiti PowerBeam 5AC 500 2020-05-17 21:03:30 +02:00
image ath79: add support for Ubiquiti PowerBeam 5AC 500 2020-05-17 21:03:30 +02:00
mikrotik ath79/mikrotik: load caldata via sysfs loader 2020-05-08 15:17:17 +02:00
nand ath79: fix wmac initialization for Zyxel NBG6716 2020-04-13 19:21:56 +02:00
patches-4.19 kernel: bump 4.19 to 4.19.122 2020-05-12 12:36:28 +02:00
patches-5.4 kernel: bump 5.4 to 5.4.41 2020-05-14 13:33:40 +02:00
tiny ath79: add support for TP-Link TL-MR3420 v3 2020-04-06 11:55:24 +02:00
config-4.19 ath79: remove unused TP-Link partition parser 2020-04-27 12:20:41 +02:00
config-5.4 ath79: remove unused TP-Link partition parser 2020-04-27 12:20:41 +02:00
Makefile
modules.mk