ca7f9638d5
I recently picked up a WNDR3700 to put OpenWRT on, and only after tearing into the box did I find it was one of the v3 boards, with poor OpenWRT support. This patch should add the board detection and LED/button control to the broadcom-diag module, and should generate a netgear .chk image that the bootloader and stock firmware will accept. The changes to the broadcom-diag module are more than a few lines because the WNDR3700v3 is driving its LEDs through an HC164 8-bit shift register. Signed-off-by: Owen Kirby <osk@exegin.com> SVN-Revision: 36482 |
||
|---|---|---|
| .. | ||
| acx-mac80211 | ||
| admswconfig | ||
| apex | ||
| base-files | ||
| block-mount | ||
| boot | ||
| broadcom-diag | ||
| broadcom-wl | ||
| busybox | ||
| devel | ||
| fuse | ||
| hotplug2 | ||
| kernel | ||
| libs | ||
| linux-atm | ||
| lua | ||
| mac80211 | ||
| mkelfimage | ||
| mountd | ||
| mtd | ||
| network | ||
| opkg | ||
| platform/lantiq | ||
| procd | ||
| px5g | ||
| switch | ||
| system | ||
| toolchain | ||
| trelay | ||
| ubox | ||
| ubus | ||
| uci | ||
| udev | ||
| util-linux | ||
| zram-swap | ||
| Makefile | ||