Roger Pueyo Centelles a0ef42e77c ath79: add support for Ubiquiti PowerBeam 5AC 500 ... The Ubiquiti PowerBeam 5AC 500 (PBE-5AC-500) is an outdoor 802.11ac 5 GHz bridge with a radio feed and a dish antenna. Specifications: - SoC: Qualcomm Atheros QCA9558 - RAM: 128 MB DDR2 - Flash: 16 MB SPI NOR (mx25l12805d) - Ethernet: 1x 10/100/1000 Mbps Atheros 8031, 24 Vdc PoE-in - WiFi 5 GHz: QCA988x HW2.0 Ubiquiti target 0x4100016c chip_id 0x043222ff - Buttons: 1x (reset) - LEDs: 1x power, 1x Ethernet, 4x RSSI, all blue - UART: not tested Not supported: - RSSI LEDs (probably through 74HC595 chip) Installation from stock airOS firmware: - Follow instructions for XC-type Ubiquiti devices on OpenWrt wiki at https://openwrt.org/toh/ubiquiti/common Signed-off-by: Roger Pueyo Centelles <roger.pueyo@guifi.net>		2020-05-17 21:03:30 +02:00
..
base-files/etc/hotplug.d/ieee80211
dts	ath79: add support for Ubiquiti PowerBeam 5AC 500	2020-05-17 21:03:30 +02:00
files	ath79: ag71xx: unify version dependent code	2020-04-27 12:21:45 +02:00
generic	ath79: add support for Ubiquiti PowerBeam 5AC 500	2020-05-17 21:03:30 +02:00
image	ath79: add support for Ubiquiti PowerBeam 5AC 500	2020-05-17 21:03:30 +02:00
mikrotik	ath79/mikrotik: load caldata via sysfs loader	2020-05-08 15:17:17 +02:00
nand
patches-4.19	kernel: bump 4.19 to 4.19.122	2020-05-12 12:36:28 +02:00
patches-5.4	kernel: bump 5.4 to 5.4.41	2020-05-14 13:33:40 +02:00
tiny
config-4.19	ath79: remove unused TP-Link partition parser	2020-04-27 12:20:41 +02:00
config-5.4	ath79: remove unused TP-Link partition parser	2020-04-27 12:20:41 +02:00
Makefile
modules.mk