1984a6bbca
When support for Luma WRTQ-329ACN was added, the instructions for flashing this device include using tools from uboot-envtools package. Unfortunately the OpenWrt buildroot system omits packages from DEVICE_PACKAGES when CONFIG_TARGET_MULTI_PROFILE, CONFIG_TARGET_PER_DEVICE_ROOTFS, CONFIG_TARGET_ALL_PROFILES are set. In result the official images are without tools mentioned in the instruction. The workoround for the fashing would be installing uboot-envtools when booted with initramfs image, but not always the access to internet is available. The other method would be to issue the necesary command in U-Boot environment but some serial terminals default configuration don't work well with pasting lines longer than 80 chars. Therefore add uboot-envtools to default packages, which adds really small flash footprint to rootfs, where increased size usually is not an issue. Signed-off-by: Tomasz Maciej Nowak <tmn505@gmail.com>
25 lines
546 B
Makefile
25 lines
546 B
Makefile
include $(TOPDIR)/rules.mk
|
|
|
|
ARCH:=arm
|
|
BOARD:=ipq40xx
|
|
BOARDNAME:=Qualcomm Atheros IPQ40XX
|
|
FEATURES:=squashfs fpu ramdisk nand
|
|
CPU_TYPE:=cortex-a7
|
|
CPU_SUBTYPE:=neon-vfpv4
|
|
SUBTARGETS:=generic mikrotik
|
|
|
|
KERNEL_PATCHVER:=5.4
|
|
KERNEL_TESTING_PATCHVER:=5.4
|
|
|
|
KERNELNAME:=zImage Image dtbs
|
|
|
|
include $(INCLUDE_DIR)/target.mk
|
|
DEFAULT_PACKAGES += \
|
|
kmod-usb-dwc3-qcom \
|
|
kmod-leds-gpio kmod-gpio-button-hotplug swconfig \
|
|
kmod-ath10k-ct wpad-basic-wolfssl \
|
|
kmod-usb3 kmod-usb-dwc3 ath10k-firmware-qca4019-ct \
|
|
uboot-envtools
|
|
|
|
$(eval $(call BuildTarget))
|