ipq40xx: essedma: enable VLAN tag offload for single-port
Enable the VLAN tag offloading mechanism for RGMII single-port devices. This allows those devices to use 802.1Q VLANs on the ethernet port. Previously, RX frames were double tagged, as the RX TAG removal flag was not enabled and an additional 802.1Q header was inserted elsewhere in the code. On the TX side, tagging was completely not present for single-port devices. Enable tagging if an 802.1Q frame should be transmitted and disable the default tagging mechanism for single-port devices. Tested on Aruba AP-303 Signed-off-by: David Bauer <mail@david-bauer.net>
This commit is contained in:
parent
e289f18347
commit
2e6c236abd
@ -164,10 +164,8 @@ static void edma_configure_rx(struct edma_common_info *edma_cinfo)
|
||||
/* Set Rx FIFO threshold to start to DMA data to host */
|
||||
rxq_ctrl_data = EDMA_FIFO_THRESH_128_BYTE;
|
||||
|
||||
if (!edma_cinfo->is_single_phy) {
|
||||
/* Set RX remove vlan bit */
|
||||
rxq_ctrl_data |= EDMA_RXQ_CTRL_RMV_VLAN;
|
||||
}
|
||||
|
||||
edma_write_reg(EDMA_REG_RXQ_CTRL, rxq_ctrl_data);
|
||||
}
|
||||
@ -1411,12 +1409,10 @@ netdev_tx_t edma_xmit(struct sk_buff *skb,
|
||||
}
|
||||
|
||||
/* Check and mark VLAN tag offload */
|
||||
if (!adapter->edma_cinfo->is_single_phy) {
|
||||
if (unlikely(skb_vlan_tag_present(skb)))
|
||||
flags_transmit |= EDMA_VLAN_TX_TAG_INSERT_FLAG;
|
||||
else if (adapter->default_vlan_tag)
|
||||
flags_transmit |= EDMA_VLAN_TX_TAG_INSERT_DEFAULT_FLAG;
|
||||
}
|
||||
if (unlikely(skb_vlan_tag_present(skb)))
|
||||
flags_transmit |= EDMA_VLAN_TX_TAG_INSERT_FLAG;
|
||||
else if (!adapter->edma_cinfo->is_single_phy && adapter->default_vlan_tag)
|
||||
flags_transmit |= EDMA_VLAN_TX_TAG_INSERT_DEFAULT_FLAG;
|
||||
|
||||
/* Check and mark checksum offload */
|
||||
if (likely(skb->ip_summed == CHECKSUM_PARTIAL))
|
||||
|
Loading…
Reference in New Issue
Block a user